How to Use and maintenance of open touch monitor
Due to technical limitations and different equipment environments, open frame touch monitor cannot be used normally due to pollution such as water droplets and dust on the screen. Therefore, the touch screen also needs regular maintenance like ordinary machines, and because the touch screen is a variety of electrical equipment highly integrated touch all-in-one device, so you should pay attention to the following problems when using and maintaining it. Use and maintenance of open touch monitor:
- Before turning on the device, wipe the screen with a soft dry cloth.
- Apply glass cleaner to clean dirty fingerprints and oil stains on the touch screen of the embedded touch monitor.
- Turn on and off the power strictly according to the regulations, and turn off the power in the reverse order.
- The simplest anti-mouse mode that is sufficient for the application should be selected, because complex modes need to sacrifice latency and system resources.
- The touch screen controller can automatically judge the dust, but too much dust will reduce the sensitivity of the touch screen, just wipe the screen with a dry cloth.
- Drops of water or beverages falling on the screen will cause the software to stop responding. This is due to the similar characteristics of water droplets and fingers, and the water droplets need to be wiped off.
- A large number of temporary files are generated on the hard disk. If there are frequent breakpoints or shutdown without exiting Windows, hard disk errors will soon occur. It is necessary to run Scandisk regularly to scan hard disk errors. It is best to set a password in the application to exit the application and Windows to restart. power off.
- Depending on the harsh environment, regularly open the advice head to clean the reflective stripes and the inner surface of the touch screen of the open frame touch monitor. Open the mechanism to release the lock tongue, lift the front of the machine head, you can see the embedded touch screen control card, unplug the touch screen cable, move the device head back to remove the device head and touch screen, look carefully after fixing the touch screen, remove the touch screen and clean it. Be careful not to use hard paper or cloth, and don’t scratch the reflective stripes. Finally, restore the device head in reverse order and original structure.